![]() ![]() This time I got the message that the serial port could not be found. I installed Cura there and connected the printer via USB. Then I tried using Ubuntu 14.04, running on a virtual box. ![]() I installed the latest Arduino drivers as well as the FTDI drivers, but no luck.Ī new arduino board (connected via USB) was also not recognized. I'm running out of ideas what to do differently in order to get my newly assembled Ultimaker Original finally up and running.Īssembly went all well, however when I tried to connect the printer via USB to Cura 14.03, Windows 7 (64bit) would not recognize the printer (error code #43).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |